phaseThis is the most urgent question that everyone wants to know.

How can you enjoy a warm and comfortable bath during the cold season? Aidiyou is here to guide you.

1. lamp warm

First of all, warm lights are a common way of heating. It heats up immediately and heats up quickly, but the heating range is relatively small and uneven up and down, which is more suitable for small spaces. During installation, due to the high humidity in the shower area, all power wiring must not only be waterproof, but also embedded in the wall to ensure safety. In addition, warm bulbs are easily damaged. It is recommended to choose an explosion-proof lamp with a high safety factor to avoid potential safety hazards.

2. wind warm

The wind is warm compared to the lamp is warm in safety, and it also has the function of ventilation. However, wind heating requires preheating time, which is more powerful and therefore more expensive. When installing, also be careful not to install open wires to ensure safety. In addition, the installation position of the wind heating is not recommended directly above the shower area, and can be slightly offset to avoid the discomfort caused by direct blowing.

3. radiator

Radiators are the preferred way of heating for the vast majority of people. It dissipates heat quickly and evenly, has high comfort, and can also be used as an electric towel rack. At the time of installation, the steel radiator is the most cost-effective and is a good choice. At the same time, considering the effect of heat preservation and heating, the installation position of the radiator should be low and not high. In addition, the radiator also need to be moisture-proof anti-corrosion treatment, so as to avoid the liner rust affect the service life.

4. floor heating

Although it is not common to install floor heating in the bathroom, it is not infeasible. The comfort of floor heating is extremely high, but the construction requirements are high, and the later maintenance is not easy. During installation, it is recommended to install the floor heating only in the dry area, and do a good job of waterproofing, especially pay attention to the waterproof treatment of the corner positions such as the threshold stone and the floor drain. Because the bathroom area is small, so the heating area does not have to be too large, so as not to waste energy.

Choose the right heating method and install it correctly, allowing you to enjoy a warm and comfortable bath time in the cold winter.